16kN Lifting Tirfor Hand Winch Manual Tirfor Winch 25kN Pulling

Pulling capacity

ADVANTAGES

Simple structure and powerful function

• Fast and easy installation, Simple to feed in or remove the wire rope, Continuous operation without snatching, Changeover from forward to reverse operation by transferring the operating handle from one lever to another, Works in any position horizontal, vertical or angled.

The length of the wire rope is not limited

• Standard length of steel wire rope is 20 meters but custom length s available on request.

Safe and reliable

• Each Hoist is tested to 1.5 times of the rated capacity. The jaws and connecting axle have been quenched, and the modules have been electroplated. The performance of the products will not be affected after the four-fold strength test.

Increase the nominal capacity with multiple sheave blocks

• The rated load of the machine can be increased with the snatch block and the traction direction of the machine can be changed by the fixed snatch block or fixed object.

Safety device to prevent overloading

• Each Hoist has a built in shear pin which is designed to break at approximately 25% above the working load limit, this prevents excessive over loading. The pins can be replaced without releasing the load. two spare pin s are located In the carry handle.

Load positioning accurate to mm

• Whether lifting or lowering, the load is permanently controlled with the utmost precision; when operation st load is spread between the two jaw blocks.